- Two Channels
- Speakon Connectors
- Dual Binding Post Speaker Output
- Two Way Crossover
- Low cut switch
- Crossover switch (150Hz X over)
- Thru/Low Out jacks
- High out jacks
- Three Speakon Connectors (CH A/CH B/Bridge)
- Sub- Sonic (Low Cut) Filter
- Two-Speed Fan
- 2 Ohm Load Per Channel
- 4 Ohm In Bridge Mode
- Combo Inputs Connector Xlr/1/4''Phone Jack Connector.
- Thru/Low Out And High Out ¼'' Jacks
- 110/220 Volt Switchable
- 2x5 Led Input Level Indicator
- Overload And Protection Indicator
- Signal/Noise Ratio:=102db
- Distortion:=1.0%
- Frequency Response:20hz-20khz Less Than±0.5db
- Input Impedance: Balance 20ko
- Input Level:+4db
- Total Power 3000 Watts
- Sold As: Unit
This two-channel rack-mountable amp's got power - 3000 watts Each input takes RCA, XLR, or ¼' phono. Control each channel with an illuminated knob. A clipping LED reminds you to turn it down if your signal is distorted. Use in stereo, mono, or bridge mode for maximum output.Connect your speakers using the two Speakon inputs, or use the shock-free banana plugs on the back. The heavy duty fan with aluminum heat sink and protection circuit guards your equipment for optimum performance.
;)
